goin bck to twin carbs

[BansheeBoy96]

Tired of two into 1 carb holding me back goin bck to stockers need to know where to start with jetting.....running 370 sleeper stock hot rods crank +4 timing v force 2 reeds stage 4 head 19cc domes dyno fs stage 4tuned klotz nitro in the gas with klotz two stroke oil 32:1 mix billet impeller engine ice....where to start with jetting???

[BUILDER]

Elevation

[hp2000]

Tired of two into 1 carb holding me back goin bck to stockers need to know where to start with jetting.....running 370 sleeper stock hot rods crank +4 timing v force 2 reeds stage 4 head 19cc domes dyno fs stage 4tuned klotz nitro in the gas with klotz two stroke oil 32:1 mix billet impeller engine ice....where to start with jetting???

 

What size carb we're you running before and what manifold on the single set up?

[BansheeBoy96]

Trinity stage 4 manifold 35mm KEININ carb 188main 45pilot needle is n the middle goin bck to stockers tors removed where to start..... Riding in north Carolina

Edited September 13, 2011 by BansheeBoy96

[jbooker82]

port it and buy another 35

[BansheeBoy96]

Already mildly ported mx/woods but was told another 35 would lean it out........

[jbooker82]

I dont know how running another carb would lean it out. You will need to jet them. Probably a pwk 28's would be better than 35's if you have a mild port job.

[BansheeBoy96]

Would 35s be to much

[hp2000]

Toss the trinity manifold and get a custom long tube one. mine is from bobs manifolds in yucaipa Ca. And works amazing im also on a 38mm pwm.

[BansheeBoy96]

How well does it work with porting and my existing mods