Pipe?

[shee4-life]

New hear ,just wanted to give you guys a shout out. I'm haveing a 4mill built and i have tommey t-5 pipes will these work ,if not i was thinking shere in frame. Are there any guys on here from nebraska thanks for your time. i have a lot more ?'s i just don't want to get burned on this build.

[alf44]

I run toomeys on my 4mill, only because i havent put on my CPI's yet. If your going more for drag racing go with the sheare. The CPI is a more well rounded pipe for all types of riding. Hit me up anytime if you need them or anything else.

Welcome to the site.

[madjimmax]

The T-5s should run great. Whos doing your motor work for you? And welcome to the HQ

[shee4-life]

The T-5s should run great. Whos doing your motor work for you? And welcome to the HQ

A guy out of Grand island Nebraska

[dragbanshee98]

A guy out of Grand island Nebraska

ask the motor builder what will work for ur riding type and motor setup.

[b-nasty]

Brent does good work, He ported my cubs and my buddy's stock cylinder 4mm. Does a good job and knows his shit..

[RagunCajun]

CPI's come on a little later than t5's but CPI's rev higher and pull harder on top. Shearer's are basically an inframe drag pipe. They will hit later than CPI's but rev out more and pull harder on top.

 

It's personal preference.

Edited July 19, 2010 by RagunCajun

[bbcmudtruck]

The T5s will work ok on a stock cylinder 4mil motor. However a set of Rockets will come on sooner and pull alot harder.

[shee4-life]

The T5s will work ok on a stock cylinder 4mil motor. However a set of Rockets will come on sooner and pull alot harder.

Thanks for all you guys help, just have to make up my mind.