Jump to content

Recommended Posts

Posted

More easy questions for you. Do I got a desert tank? I notice most grills screw in from the side, and my tank goes over where the screws would be.

 

My Shee smokes pretty good.... Im mixin at 40:1 sound good?

 

The damn kickstarter jingles like crazy while its running.... It drives me nuts.... is it just worn out and need replaced? And the kick starter slips past the stop and allows me to kick it all the way down.

 

I was cleanin her up ... and found this. Vent tube or something... where does this go???

 

Thanks guys, I just posted some pics of my Shee comment away

post-35091-12669739638315_thumb.jpg

Posted

That vent hose goes in the back of the moter rite in the middle of the cases below the rear motor mount.

 

40:1 is what i mix mine at, what kind of oil are you running?

 

Kicker just needs rebuild to get it to stop ratteling, as far as it sliping past the stop it may be bent or just wore out. They are pretty cheap on here or ebay.

 

The bike looks good from what I can see, post some more pics of it.

Posted (edited)

That vent hose goes in the back of the moter rite in the middle of the cases below the rear motor mount.

 

40:1 is what i mix mine at, what kind of oil are you running?

 

Kicker just needs rebuild to get it to stop ratteling, as far as it sliping past the stop it may be bent or just wore out. They are pretty cheap on here or ebay.

 

The bike looks good from what I can see, post some more pics of it.

 

 

Thanks. what about my tank?? I posted some pics in the gallery.

 

Can i rebuild the kicker? Ill check the oil tomorrow i forgot.

 

Any more suggestions? Front air pressure 8 rear 8? Super rocky desert hills .....there Holeshots 22 front 20 rear

post-35091-12669900313501.jpg

Edited by havasu
Posted

Thanks. what about my tank?? I posted some pics in the gallery.

 

Can i rebuild the kicker? Ill check the oil tomorrow i forgot.

 

Any more suggestions? Front air pressure 8 rear 8? Super rocky desert hills .....there Holeshots 22 front 20 rear

if you want more traction drop the rear tire pressure in half

Posted

if you want more traction drop the rear tire pressure in half

 

Alright I took her out today, first time riding it here in Arizona. Im from Seattle. Way rockier than I thought, my 20" rears are way to small, should of bought 22's DAMN> Cant lower the pressure anymore cuz that will bring my closer to the ground. Rear skid plates hits alot of rocks.

 

I still cant find where the vent tube goes (FIRST PIC TOP OF POST) If someone could snap a shot that would be cool.

 

The quad ran Great, Very Ping-y and full of power. I was looking it over when i got home and I noticed the Intake boot (or w/e its called) is ripped! Can i just put some black silocone gasket maker stuff on it for now?

post-35091-12670497834448_thumb.jpg

Posted

The quad ran Great, Very Ping-y and full of power. I was looking it over when i got home and I noticed the Intake boot (or w/e its called) is ripped! Can i just put some black silocone gasket maker stuff on it for now?

 

I'm no expert but if it was my shee, I would take the time to fix that problem correctly before riding it for long periods of time or in dusty conditions. I would not use silicone gasket on the balance tube boots. If the gasket material breaks down it would get sucked right into the cylinder. I'm suprised its not running lean on that side (if it is leaking air through it).

Posted

I'm no expert but if it was my shee, I would take the time to fix that problem correctly before riding it for long periods of time or in dusty conditions. I would not use silicone gasket on the balance tube boots. If the gasket material breaks down it would get sucked right into the cylinder. I'm suprised its not running lean on that side (if it is leaking air through it).

Not a man with many posts ^^^^^^ but that is true words of wisdom! Also just replace the chain rollers because its better to fix things before they break!

Posted

Nice bike man, I was checking it out in the gallery. Ive got the same tank on my bike, do the bars rub on it at all when they are cranked to either side?

 

As far as the intake boot is concerned, replace both of those right away man. For $20 on ebay, you can get new replacements and get rid of the risk of leaning her out and potentially melting a piston. I just bought a bike from a guy who didnt realize the intake boots were cracked, and it resulted in a bad score in the exhaust side of one of the cylinders.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...