crombie Posted November 2, 2009 Report Posted November 2, 2009 hi all. my swing arm chain slide has worn thru and come of so i need a new 1 but im not sure what they look like so i dont no what to order. does anyone have any pics or links. its the one just after the front sprocket Quote
fastbanshee8 Posted November 2, 2009 Report Posted November 2, 2009 It's called a chain slider. There's one pictured here, and you'd probably be better off checking with one of the site sponsor's, as they all should have them in stock. http://www.kdcycle.com/partsdatabase.html?prod_id=1003 Quote
crombie Posted November 2, 2009 Author Report Posted November 2, 2009 do you have a pic of one fitted. does the swingarm need removed to fit it Quote
fastbanshee8 Posted November 3, 2009 Report Posted November 3, 2009 (edited) With most of the chain sliders, you have to remove the swing arm to install them, however, there is one that you can install, with the swinger on the quad. I can't remember who makes it though. Check with FAST Racing. He's a site sponsor, and can answer your questions. I don't have a picture, as I don't run one. I have a different setup. Edited November 3, 2009 by fastbanshee8 Quote
MILO Posted November 3, 2009 Report Posted November 3, 2009 I used the UPP Racing kit on mine. You do have to remove the swinger for the initial installation though. It seems to be holding up pretty good so far. UPP Racing Quote
badjetman23 Posted November 3, 2009 Report Posted November 3, 2009 i got a tm design works slide and roller kit and it is awsome you dont have to take the swinger off to put it on. This roller slide and glide kit is awsome Quote
WantABanshee Posted November 3, 2009 Report Posted November 3, 2009 any pics with it installed? Quote
shanYE west Posted November 3, 2009 Report Posted November 3, 2009 I had a UPP slider.. You didn't need to remove the swingarm to put it on. It was split and had a bolt that pinched it together. I prefer the modquad though. Quote
black sunshine Posted November 3, 2009 Report Posted November 3, 2009 Make sure you didn't allow the chain to rub through the oil seal for the swingarm pivot (like I did!). Then you will have to partially remove the swingarm to put in new seals and bearings anyway. The swingarm does not need to come all the way off the bike, fyi Quote
crombie Posted November 3, 2009 Author Report Posted November 3, 2009 I have got the swingarm and linkage of to replace all the bearings and fit a twin row bearing carrier. im wanting to get all the bearings fitted as soon as they arrive so i ordered a chain slide that opens up to fit Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.