My carsb have different slides in them....wtf?

[RippinShee]

I bought a set of used Keihin PJ 34's and have had them installed in my bike for about a week now. I was syncing the carbs and noticed the slides look different. I pulled them out and left left one at the bottom, the taper is huge, like the big u at the bottom. The right side is much flatter. WTF?

[blowit]

I bought a set of used Keihin PJ 34's and have had them installed in my bike for about a week now. I was syncing the carbs and noticed the slides look different. I pulled them out and left left one at the bottom, the taper is huge, like the big u at the bottom. The right side is much flatter. WTF?

 

 

Better get a hold of the seller because you have an issue there and the original owner likely knows about it. Yes, they should match.

 

B

 

EDIT: OK, I got it, the original owner drag ported only one cylinder and woods ported the other so he could have the best of both worlds..damn, where are my smileys when I need them...

Edited October 5, 2009 by blowit

[Tedder]

Yep, They need to match. Hard to say if the seller knew about it or not.

You'll probably only need to buy for one carb.

Keihin link: http://www.keihin-us.com/slide.htm

Sudco link: http://www.sudco.com/Diagrams323728/exppj.gif

Edited October 5, 2009 by Tedder

[sleeper06]

Same thing happened to me from this guy from NC,I was told they were35mm PWKs but I measured the ID of the carb throat and they were two diffrent carbs,needless to say I got screwed so watch out.He told me I was switching carbs out,for what I dont know!!!