What jetting set up to use?

[333bbb333]

Ok I have a freshly rebuilt motor and I want to make sure my jetting is right before I start.

I have a stock bore, Toomey T-6 pipes, 28mm flat slide carbs, no Airbox just single filters on individual carbs, and some carbon fiber reeds on stock cages and that is about all the mods I have done. .

Also I am at sea level, what mains and needle position would be a good starting point?

[locogato11283]

flatslides are mikunis right? so the jetting should go in the same increments as stock carbs? is that right? if so, id try a 27.5 pilot and 310 mains..