banshee not idling right

[mordecai]

i had just bought an 01 banshee about a month ago and it ran pretty good, but i thought i better check the carbs and clean them if the needed to be after i put everything back one side of it is running rich on idle and it wasn't doing that before, the settings and jets are the same on both carbs, i took a look at the reeds and they were fine, i put new plugs in but that didn't help i also checked the compression and that was good

 

so any help would really be appreciated, thanks

[bbcmudtruck]

Make sure the slides are opening at the same time. Press the throttle and watch the carb slides. They should move at the same time. If they do not, first make sure the caps are screwed on tightly. Next adjust the carb tops where the cable enters. Also make sure that your choke tube is connected between the carbs. Ensure that you put the slides back in the correct way. When looking into the rear of the carb, check to make sure the at the bottom of the slide is cut away like a half moon.

[Trixyboi14]

Hi, I have just read this topic because your problem sounds exactly like mine right now. Im gna re-sync my carbs n do the other stuff mentioned above. Wanted to no if this fixed your problem?

[TwistedSheeRida]

if you havent gotten the tors removal kit yet do that i usually measure the slides at the bottom for idle with a drill bit to make sure they are the same height

 

[Huey73]

Going through the same thing right now too! Flooding out bad on the left side. Replaced the needle and seats on both carbs. Just thought that it might be the choke because its on that carb. I'll report back when I get it figured out