carbs

[fastrthnu]

I have a pr of 28mm flatslides with some tricks (29.25 bore with atomization swirl grooves) that I made myself. I run a low and high end motor. I dont really drag but do a cross of mx, gncc, and TT. Im debating on weither or not I should stick with these or get some 34`s. I like knowing I have a good low end flow velocity, but I think I might still gain more with a 34mm. I have RZ 12port cylinders matched to rockets, 4mm stroker, pods, displacing 385cc`s. Seems to me like it might be to much, but I have sen alot of people using 34-35mm with similar mods or even slightly less.

 

Also of course it shouldnt be a matter as of yet, but of course it will be rising in displacement, and once maxed, 68mm sleeved will be goin in.

[fastrthnu]

nm, I think Im going to get some 32mm`s, I think I can keep the same intake then too?

[BigRed350x]

I run 38's on my duner with a displacement close to yours. You would like the 34's on a 4mil setup.

 

- Jared

[locogato11283]

go with a pwk model carb.

[fastrthnu]

thankith thou forith thou input

[fastrthnu]

thankith thou forith thou input

 

you can use stock intakes up to 32mm though right?