Front SS Lines

[LiftdT4R]

Hey, what's up? I was wondering what everyone was running for SS front lines. I definately want the ones that have a single cable, down to a splitter, not the one where you have to stack the fittings at the front res. I have a set now, that I bought used from a member on here, and they recently started leaking at the T connector, not sure whats wrong with it, but they looked pretty dingy when I picked them up anyway. Anyway, just wondering what you guys were all using. Lemme know!! :beer:

[desertdeweller]

do you have an fittings on the ones you are running? They don`t usually have problems with those fittings. Mine are from atv racing they came with the a arms that I purchased from them. they have a clear protective liner over the steel braid to keep it from getting torn up,a lot of a companies sell them.

[LiftdT4R]

do you have an fittings on the ones you are running? They don`t usually have problems with those fittings. Mine are from atv racing they came with the a arms that I purchased from them. they have a clear protective liner over the steel braid to keep it from getting torn up,a lot of a companies sell them.

 

Mine are leaking out of the threads in the t-fitting. I've never had a lot of luck trying to seal up brake line fittings with any kind of loctite or tape. No matter what I use the fluid ends up eating through it and leaking again. For the $60 a new, hoepfully better, set would cost, Id rather do that and never have to worry about it.

 

If anyone has any ideas for sealing the threads though, lemme know.

[rtcc]

good ol rockymountain has a few. They sell the galfer stuff which is nice or they have their own tusk stuff. I dont run either, I am waiting to get the double line from the master cylinder ones, I think the t fitting will always be weak link in the system.