Search the Community
Showing results for tags 'throttle'.
Found 3 results
-
My banshee always ran at around 80-90 degrees Celsius I have a temp sensor the last night I was out in the snow it was running at 90-110 and was constantly getting hot so I resorted to cooling it with snow up on the exhaust every time also the throttle was sticking wide open a lot where I would have to clutch and blip the throttle for this to stop I’m not really sure what the problem would be coolant level ok haven’t checked the water pump as sometimes I could get 25 mins without needing to cool and sometimes 5 mins which was too inconsistent in my opinion I have vforce4’s carbs have 300 main jet 30 pilot jet red needle on middle clip recently did tors delete have rode it two times since where throttle was ok has anyone else experiecned this ? -
Doing some spring cleaning and have some parts that I need to get rid of, if it doesn't sell here it is going to fleabay. Paypal gift only or pay fees. paypal is [email protected] pm me or reply with any questions. Grand River Racing Big Bore left side pipes. Small dents where they touch, underneath side at the fronts is a little dirty from oil running out, not noticeable on the bike and they look/sound great.No springs included. $275 shipped Moose ATV extended thumb throttle assembly, like new helps a lot with the stiff banshee throttle. $80 shipped Rear Marvin Shaw Hillshooter 13.5" eye-to-eye, not sure what it weight/swingarm length it is set-up for. $210 shipped +10 rear swingarm and chain included no master link $175 shipped Mikuni TMX carbs, Polished, set-up for alky or race gas. Bored to a 38 or 39 comes with cables, air filters, outerwears and alky jets. $250 shipped 36mm Mikuni TMX carbs #2 with throttle and choke cables, and intakes. $200 shipped. PD Coolhead domes 18cc cut for a 4mil $50 shipped Stock a-arms, hubs and spindles $200 shipped Stock headlights, the plastic wire covers on the one have been broken in the middle but they still function great. Square plug. $60 shipped