Jump to content

ryanrogers

Members
 View Profile  See their activity

  • Posts

    12

  • Joined

  • Last visited

 Content Type 

Everything posted by ryanrogers

  1. ryanrogers
    if i put the choke it seems to help it and at high rpms it seems to be ok so the pilot makes sense thank you
  2. ryanrogers
    my banshee isn't firing in the left cylinder. vf4 reeds, pro circuit pipes, shaved head, and k and n pods other than that motor is stock. has 155 psi in both cylinders. i tried switching the coil wires on the plugs and it didn't change. any help would be greatly appreciated thanks
  3. ryanrogers
    i'll try that thank you
  4. ryanrogers
    it seems to be in the clutch but i'm not sure it just starts pushing oil out of the dipstick/ fill plug but i did put a new o-ring on the coolant tube
  5. ryanrogers
    my bike is pushing coolant into the cases and i'm not sure where from. it is a fresh rebuild with about 2 hours on it.
  6. ryanrogers
    i have the same pipes with k and n pods and 300 mains and 30 pilots in it right now but it is rich all the way through
  7. ryanrogers
    check the stator for rust, mine did that when I bought it after it had sat for a while. had to clean the rust of the ends and ran fine since
  8. ryanrogers
    i am going to put k and n pods on my bike and was looking for a quality bracket to mount my overflow tank. any suggestions
  9. ryanrogers
    I run yamalube at 32:1 with no issues
  10. ryanrogers
    thanks I have the jets on order should be here in a couple days
  11. ryanrogers

    waiting on deliveries

  12. ryanrogers

    can I ask you ask you a question

  13. ryanrogers
    I have a 2001 banshee pro-circuit pipes, stock bore, stock porting, K & N filter in air box (no lid), v-force 4 reeds, +4 degrees timing, and head has been shaved .020. Compression is at 150 on both cylinders. I usually ride in an area around 1000 feet above sea level

BHQ Quick Links

×
×
  • Create New...