Scooter350

I will definitely do that cuz i adjusted the floats again, seemed to have no leaks at the time but i went threw it and measured both seemed correct seats good but i would doubt that a rebuild thanks for the info.

Thanks guys for the info. Too much of a rush makes me look stupid, ya for me.

Touchy touch screen sucks

Ya just checked it damn floats gotta be dead on don't they? Height is good its just catchin the overflow tube barely but its just enough. I wants make these carbs last till I get all the shit to go to a 421 serval then stock carbs go byebye.

Pm sent

Thats what i thought, its just passing voltage threw from the magneto and amplifying it to the plugs.

Hey blast off no shit i regret it i tried contacting this post and no response so i said fuck it. I have stock pipes anyway. Would've loved to have t5's

How much power increase did it give you???

The petcock holds"doesn't leak fuel" for some reason the overflows and the upper vent tubes barely leak but just enough to puddle on the floor. For example got home yesterday and thicker oily gas was puddled under the shee and the cases were wet under the carbs. O and one more thing ill be cruisin down the road 3rd-4th gear hammer it and i can feel the right carb kick in when its going into the powerband slides are syncd. 10lbs sledge hammer+2stock junk carbs=good stress reliever, but ill keep fuckin with em its just a pisser sometimes.

Damn just bought hp2000's fmf's 2 hours ago

So fmf is sold?

I'll check it out later and let yall know.

When its running its great no leaks no run over no flooding and the petcock has no drips I know the gaskets and screws are good n tight. The thing is it seems its the same amount of gas like two bowls worth. I move it clean it and chunk a rag down and ill be damned its like Santa pissin in my cherrios

The petcock works;I take the supply lines of the carbs to check the floats,needle,float height and put it back and next day BAM fuckin gas everywhere. This has only happened the past three days since I messed with the float on the right carb stickin and the floats work great well while running no leaks from drain tube. So I figured idle it till the carbs go dry. First time in doing this bad two stroke trick but I was at wits end. So I'm lost right now and need some advice.

Shee doesn't run with bowls dry and petcock off but still leaks gas in my shop wtf its driving me nuts!

I'll buy those pipes if you have them

Anyone have a 3D gripper seat they would sell for less than new cost?

I'll let you know by tomorrow morning. Hoping you still have them.

Jealous! Sweet bike did a great job!

Will do

Im down to go! Any sites left? Gotta get two sets off paddle tires and some pipes bad!

If you still have them could you send me pics?

Sure would be nice on my shee. U still got em?

Thanks for the heads up, ill keep my eyes peeled.

Holy cow i gotta be on it if i want a set of fullbores. New member as of today.