outlander1000

Probably end up splitting the case tomorrow then.

I was in too much of a hurry and forgot to explain it a bit more. It has good compression ~180#, kicks fine and is getting fuel. As far as it not starting I think it is a reed issue or a sheered flywheel key but I can deal with that later. It will roll the machine forward when in gear (no clutch) and kick it over. Thinking it is an issue with the chain binding when it has a load on it but didnt have any problems. I did spray it down (whole bike) with degreaser and left it sit before this.

My banshee was acting up after leaving it idle while I sprayed it down and tried to clean up the motor. Planned on dealing with it later but when I got it out today and see how it ran I couldnt kick start it so I tried pulling it. It will pull fine in nuetral or with the clutch pulled in but as soon as I let clutch out it will lock up the wheels in any gear. I dont think the chain is binding, but it is pretty loose. Not sure if any water could have got in from the transmission/clutch shaft seal and rusted something? I really dont feel like working on it but I had it for sale so either fix or sell for half.