possum

I got some 10x4 bluelabels on 18x4 smoothies. 180+shipping

JJA

If I actually liked fullbores id buy it

I got the best 10 mil crank

They are probably 1/2x20 thread. How tall are these? Some are to tall.

I dont even measure, I eyeball it. I hold the carb upright and bend the tab and lift the float till it hits the lil pusher needle on the way up. But not letting the lil pusher needle bottom out before the float is all the way up. That is the correct way, and ive never had an issue EVER.

Seats must be leaking, probably dirty. You shouldnt have an issue if seats seal off.

10 xtremes 72-74 roll sls on 8x8

The sb oof would be faster in drag race. 8500-10000 is where the shift points are at. And it has more overrev at 11000

LEDs are shit, id rather run fmfs

Lol

Ill bring the axle if you want it.

I know of one in the IE. CHEAP 10mil cheetah, marvins, shearers, lightened tiger chassis, alky pwks, lockup, 2-5 override all the goodies. Pm me

Theres nothing you can do about the dissengagment. It doesnt have enough throw to release 100%.

Why are you asking people here? Im sure Kan can tell you all you need to know. I just have a feeling you're clueless.

If forged is done right it will be plenty strong and long lasting. Ive seen billets let go just as often.

Nah. It will cost me 30-40 to ship it. Ill just keep it for that.

Herr jugs

Yup it was on a banshee already. 100 + shopping. I woild have to find out shipping price

I got a blaster axle beef.

I agree with Camatv on the fact of, why not cast them ported. Basically port yourself a set and get dyno time on it if you have to even. Work all the porting out as a drag cyl. Then mass produce that. Same with a duner built cyl, Same process. So when people buy these. They are bolting on very well sorted out porting as cast. THAT will put you miles above the rest.

If you want to drag race at olds, camp at the washes or on sand highway near the store. Wash 4-5 is a straight shot 15 min ride to olds on a bike. Or drive in to olds from the wash in a truck pulling bikes is the best way for drag bikes. By truck its 20-30 min from the store to olds. From this side of the dunes, you can get to all the best dunes and olds hill. If you camp at gecko rd and want to race at gecko flat drags. And tons of dunes as well. From the store/washes to gecko rd is about a 15 drive in a vehicle. Sand highway runs along side the highway. About a 40 min ride on a duner depending how fast you ride. I prefer the washes, harder packed if you have an rv, way closer to olds hill, closer to china wall and huge dunes etc.. If you plan to dune bring ALOT of fuel. You can do 10gal a day easy on a banshee if you go on a few trips. If racing, olds is usually whooped and chopped to hell. Not sure if someone grades it, usually not. So good luck going fast there. Also rangers are everywhere busting people for anything All in all, go to Dumont for prez weekend. 1000 times better. In all ways possible.

How wide do the tires actually measure

I run 20:1 all day. Less wear on errthang

Top