bansheekx
-
Posts
82 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Store
Everything posted by bansheekx
-
Check to make sure the pressure plate is installed correctly, it is possible to have turned a little and it will not press on the clutch plates. The square notches on the plate should set in the grooves in the clutch hub.
-
Make sure that the ball for the clutch push rod did not fall out, If it did that can cause this to happen.
-
Those look like old school fmf silencers to me.
-
I would just cut them off, its a lot easier to clean your bike up when you dont have the fenders holding all the mud.
-
I fixed a dent on the pipe on my kx by putting a rubber expansion plug in the jug side that has a bolt in the center to expand it. Then I clamped a short air hose with an air chuck to the small end. I then put around 80 pounds of pressure on it and heated it up with a map gas torch, if you take your time it works pretty good.
-
Good guy to deal with, item was exactly as described and shipping was very fast. Would not hesitate to buy from again.