MikeNick

Thanks fellas...It's gettin cut off... :cool:

Sorry man, I hit post then remembered I forgot pics so I hit back an added pics and reposted therefor makin 2 topics, 1 with pic an 1 w/o..haha Sorryyyyyyyyyyyyyyyyyyy

Just looking to see if anyone has one they would like to get rid of before I buy a new one. Thanks Mike

Adjustable or stock

Is this tab here needed, the one with my finger pointing towards it. What is it for,??? I looked on my Banshee and theres nothing attached to that bolt hole on it either..Was thinkin bout cuttin that piece off b4 PC.. This would be on the clutch side of the frame also right behind where the rear master cylinder is.. I already cut off the front fender mounting brackets and original pipe hanger brackets...

Is this tab here needed, the one with my finger pointing towards it. What is it for,??? I looked on my Banshee and theres nothing attached to that bolt hole on it either..Was thinkin bout cuttin that piece off b4 PC..

Heres a set of tie rods I have for sale without the balljoints...Perfectly straight an no rust... http://cgi.ebay.com/ebaymotors/ws/eBayISAP...T&viewitem=

What the fuck are you talking about

Switch everything back to the way it was b4 and see if the noise goes away...Will it idle?

I got a plastic one...Billet just sounds bad...

DId it to it before???? It's not your kicker is it..

Also what about these stick on ones..They any count.. http://cgi.ebay.com/ebaymotors/FRAME-GUARD...sQ5fAccessories

Well I got a new frame cause mine is bent to hell and back and plan on having OHIOBANSHEE PC it for me..My question is are frame guards worth a fuck..I don't want the PC rubbin off where my boot heel rides up against my frame cause it will look like shit...Any of you guys run them and if so is DG or Pro Armor good..One better than the other I should say.....DISCUSS http://shop.ebay.com/?_from=R40&_trksi...-All-Categories

I left my Banshee sit for a month once since I had with the fuel on. Sat that long because I had it all torn apart workin on the clutch but besides that once I got it back together and went to start it once fired up it was WOT..I would kill it and start it again....I'm guessin your slides are stickin in the carbs due to it sitting for so long..If you can take them off and clean them with some carb cleaner....SLides should go up and down smoothly....Hope ya figure it out so ya can get it man..

They'd probably end up being like Namura pistons..1/2 are ok...other 1/2 are junk...haha...Might aswell get ya a good trusted set of WISECO's

SOLD or I should say traded to blessedwithdeath..

Ohhhh burn!!!

Nice rides dude..

WHAT THE FUCKKKKKKKKKKK BITCHESSS!!!

Is CAM 2 a decent high octane gas to run? It's a little cheaper than VP

WOW!

Yeah I can share Liz and the Facebook link doesnt work..grrr

Well until then we're going to need pics of you.

Can we share??? haha..Welcome to HQ..PICS PICS