rx7500hpt2

My banshee will run perfect no problems for the first 10-15 minutes then out of nowhere it will start to loose power and cut out. Start it an hour later and it will do the same thing. Could this be a bad coil? Could heat from the pipes be messing the coil up, I have older style Paul turners which pass real close.

Ok a simple question for rzshee owners. When you rev the engine, at what RPM would you say does the servomotor start to operate. Just curious because mine seems as if it does not move until its reved close to redline. Are there any adjustments?

I'm in costa mesa. As far as local stuff I'd stay away from 3 bros racing, Champion honda might cost an arm and a leg but Nick in the service department is a Real cool dude you might want to talk to him.

Anybody know of a place that sells weld on subframes or removable ones.

I was riding and out of no where it lost power and died out. I waited a minute and got it going again but it had no power like it was running on one cylinder. I had to give it full throttle to keep it moving but after a minute or two it would die out. If I'd wait a few I could get it going again and it would do the same thing. I have a couple of ideas. #1 the CDI is going bad(don't know the symtoms). Both plugs spark but the pipe is real close to the coil, so I was thinking the heat might be effecting it. #2 The head gasket blew - It was down 2 cups of coolant.

I just got some keihin 28 pwks. I need an idea of where to start with the jetting. They have 145 mains and 38 pilots now. My shee mods are - ported rz350, PTR hi revs, power reeds, toomey 2into1.

I run a toomey 2 into 1 UNI with a filter skin and outerwear. When your riding at glamis you want the best filtration possible. Filterskins supposedly filter 90% of the crap out, and they come in packs of 3 so when get one dirty you can quick change it with a pre-oiled one.