DIRTBIKEZ

Whats "cheap"?

Honestly I'm looking for a set of street beaters, but with decent rims.

The 10w30 he suggested was for the transmission. You need to mix a 2-stroke oil at a precise ratio 32:1, 40:1 or 50:1 with the fuel for "engine" lubrication.

Fix it right so it doesnt lead to other problems.

Im looking for a rear set of rims and tires.

You have a picture of those tires/wheels?

Any decent kit should... I'll let you know about the Vitos when it arrives this week.

Yes

From my understanding, you can either disconnect the TORS system (electrically) or eliminate it with a kit. The kit allows you to remove the massive carb tops and replace them with a low profile cap. Problem is that w/o these tops you cannot control the idle, so then you need to instal an idle kit.

You guys are pretty patient, I'd like to know where this guy has been for his 280+ posts.

Hockey390, lincster is talking about the "grommet" that is supposed to be in the small cutout between both "regions" (flywheel/stator and sprocket/chain) shown in your picture. **Just looked at the webpage ledofthezep posted and found a picture for you. http://216.37.204.206/wps/Yamaha_OEM/YamahaATV.asp?Type=13&A=219&B=11' target='_blank'> BANSHEE >ENGINE >>CRANKCASE >>>REF #28

It depends on how hard you hit it.

J-ARM TO A-ARM CONVERSION

I just ordered mine from Magic, $3.00 a piece. After refreshing and reentering my info ten times, the order finally went through.

Bigairee, I'd like one of those. Where/how do I send the cash?

Ebay Auction

**DIRTBIKEZ eyes his competition... and devises a plan to take him out **

Sorry man, not to diss the stealth, the MKIV Supra has got you beat before both cars even start rolling. Looks alone, its a gorgeous machine.

They are very fast... and much, much, much more expensive than a YFZ. Start saving now.

Not sure how think the cover is but my guess is its too thin the sufficently tap. Pro Design sells an E-Z Drain cover that replaces the stock cover and serves teh same purpose.

Thanks you to all who've replied.

From the schematic it looks like you need to short the Black wire with the Red/Black wire.

You saying as is now (filter w/stock pipes) or once I install the SSTs?

Never really had the chance to finish rejetting for the new K&N w/ Noss adapter but now I have a set of FMF SSTs w/ silencers on the way. Right now the snorkle is removed with 260 mains, stock pilots, air screws 1.5 turns out. Elevation here is sea level, 40-60*F, 40:1 premix. Like I said, just looking for a starting point. Thanks.

You can also check ebay. I bought an aluminum one, similar to the pro design style, last week for about $30. If I remeber correctly there were a couple more listed afterward.