toomey t5 jetting with Vforce reed cages

[sangheraent]

need help Just installed toomey t5s with Vforce 3 reeds and will install K&N intake with proflow and stock box. I also have +4 timing. I have completely stock jets and it runs horribly (only ran it for 30seconds) I am thinking of going 330main and needle clip in 4th position. I am at sealevel and will probably never go higher. no porting stock motor.

[ASRBanshee]

330 mains are too big if you decide to run your full air lid with the intake snorkel. If thats the case 280's should be suitable

[sangheraent]

no i forgot to mention im running no lid.

[sangheraent]

anybody?

[J-Madd]

I'd say leave the clip in the middle..and s far as the main, I always ran 350s with that setup. A little fat, but ran great. 300 ft elevation, 50-90 degrees. YOu didn't ask, but the stock pilot is fine w/T5s.

[johnny boy]

anybody?

im running t-5 with k&n pods and v-force3...mains are at 320 & stock pilot jet..sea level...if it helps any...but can't be stressed enough...PLUG CHOP!!!

[Michael Jackson]

if u got the lid off the box, try 280-300, 300's will prob be fat now thats its summer, if you got the toomey needles, try the 3rd clip down, 4th was too rich for me, made a huge difference in lowend just moving it up 1

Edited June 2, 2008 by Michael Jackson

[wacko2000]

I ran that setup not to long ago and I was between, 290-310 depending on weather, with some porting im up around 360-370 now..

try 310 and go from there..stock pilots will be fine, just adjust you air screws.

[sangheraent]

I put 330s in it yesterday and it runs perfectly. the plugs are a little on the wet side but I like it a little rich. I didnt touch the needles or the pilot and it starts idles and all the way through pulls without backfire,bog or anything. thanks guys!!