markyb31 Posted May 25, 2008 Report Posted May 25, 2008 I just got my bike put back together, changed all fluids and took it out for a spin. The engine runs great, but when I hit the throttle hard the engine rpms go up but it does not seem to accelerate like it should. It is almost like the tires are spining but there not. I added a little more gear case oil and it did not help. It was fine before the rebuild so I cant figure it out. The rebuild was a 80 over bore new gaskets, wiseco pro lites, and thats it. Is my clutch shot? I only had 80 psi of cylinder pressure before the rebuild, could the added power just enhance a bad clutch? I also used to run race gas and now am running 93. I cant think that would matter. Quote
Bill Posted May 25, 2008 Report Posted May 25, 2008 Cheak out your clutch plates an inspect your basket,inner hub,and pressure plate for wear/groves.Sounds like shes slippin bad. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.