schamms Posted April 7, 2008 Report Posted April 7, 2008 ok so heres the deal...i took my carbs off today and cleaned them and put them back on.(im almost positive i put them back together right) and now my banshee wont start and when i turn the gas on it just pours out of the drain off tubes that are under the bike.. any help would be great thanks Quote
peak-j Posted April 7, 2008 Report Posted April 7, 2008 (edited) Did you mess with your floats any? You might check to make sure the needles aren't worn a little bit also. Edited April 7, 2008 by peak-j Quote
schamms Posted April 7, 2008 Author Report Posted April 7, 2008 no i didnt touch the floats and the needles seemed to be fine... Quote
NitroTate Posted April 7, 2008 Report Posted April 7, 2008 take the back end of a screwdriver and tap on the bowls, your float needles are probably stuck open. That happens almost every time I take my carbs apart and clean them... Quote
MILO Posted April 7, 2008 Report Posted April 7, 2008 take the back end of a screwdriver and tap on the bowls, your float needles are probably stuck open. That happens almost every time I take my carbs apart and clean them... i agree, just tap the bowls a little and it will probably stop. if not, take it apart, double check for debris, and put it back together. it's just the float hanging up. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.