93 banshee motor.

[atvaddiction]

This motor is from a 93 banshee. It has a complete wiseco top end rebuild with less than 5 hours of ride time on it. The only oil ever used in this motor is klotz benol mixed 32:1 I would like to get $1300 for it. Below is a list of mods that were used with this motor.

 

Engine:

Klotz Benol 4oz per gallon of gas

Pro Honda 10w30 oil in clutch and tranny changed regularly

Carbs jetted with 270 main and 27.5 pilot jets and higher flowing needles

Boysen reeds

Cross over tube ports on intake manifolds have been plugged

Pro Design pro flow dual stage foam air filter with Klotz foam filter oil

Stock airbox lid modified for higher flow

FMF Fatty pipes and power core II silencers

O-ring pipe to silencer connecters

Barnett heavy-duty clutch springs

Barnett clutch plates 10% wear left

Wiseco 64.75mm prolite pistons and complete top end kit

Trued and welded Crankshaft

Adjustable +10 to -10 degree ignition timing plate set at + 4 degrees

[atvaddiction]

Best offer anyone??? No resonable offer refused!!! I just need the cash to finish my 450r

[Blewbyu]

Best offer anyone??? No resonable offer refused!!! I just need the cash to finish my 450r

$350 shipped?

[atvaddiction]

$350 shipped?

 

Thanks for the bump....

[atvaddiction]

any offers???

[zach45]

500... what bore?

[atvaddiction]

They are a 64.75 bore and i wouldnt take $500 for it because i can part out the motor and get over $1000

so i would like to get around $1000 for the complete motor.

[HotCarl]

not to be rude, but I have bought motors in $1000 range that had a lot more to offer and were in a lot better shape. If you have your heart sent on a $1000, maybe you should take the time and clean the parts up and part it out.