97yellshee Posted December 2, 2007 Report Posted December 2, 2007 1998 Banshee Cylinders that have been polished on the outside which look pretty good also they have been ported as well with a mild trail port they are in great shape, the right side has a few marks from piston blowing up but the other one is in good shape. I think the bore size is 65.25mm which i think is .050 over stock the pistons that came out of them had 1.00mm stamped on top. $250 shipped in the United States Quote
sheerider1026 Posted December 2, 2007 Report Posted December 2, 2007 1998 Banshee Cylinders that have been polished on the outside which look pretty good also they have been ported as well with a mild trail port they are in great shape, the right side has a few marks from piston blowing up but the other one is in good shape. I think the bore size is 65.25mm which i think is .050 over stock the pistons that came out of them had 1.00mm stamped on top. $250 shipped in the United States who did the port work?? is it extensive( intake, exhaust and transports?) or more of a clean up?? any pictures? Quote
97yellshee Posted December 2, 2007 Author Report Posted December 2, 2007 Picture 2 Picture 3 Picture 4 Picture 5 Quote
97yellshee Posted December 2, 2007 Author Report Posted December 2, 2007 Not sure who did the port work and i would say its a very good trail port. Quote
STREETSWEEPAZ Posted December 2, 2007 Report Posted December 2, 2007 Do you have any feedback??? What about paypal ? LMK by PM Quote
atvfreestylekid Posted December 2, 2007 Report Posted December 2, 2007 How did you get those babies shined up like that? Quote
97yellshee Posted December 2, 2007 Author Report Posted December 2, 2007 Lots of sanding and alittle polish!! Quote
Bansh-eman Posted December 6, 2007 Report Posted December 6, 2007 not too many trail ports have the boost ports in them...just glancing at those i'd say its probly a drag port or an aggressive dune port. but until you know that port timings you cant say for sure... on another note those look nice. good job polishing them up! did you use a dremel to get into the tight spots? Quote
97yellshee Posted December 7, 2007 Author Report Posted December 7, 2007 Ya i used a dremel to get in those tight areas. Quote
97yellshee Posted December 8, 2007 Author Report Posted December 8, 2007 I just mik'ed the cylinders and they measured 64.80mm. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.