g force racing axles

[samc]

my problem is that i cant fit my shee threw my gate to my backyard with out taking the right wheel off, if i buy the g force axle can i adjust it so it fits threw my gate? and then when i get out of my gate extend it back out?

[bansheeyfz]

i think with spacers.but yu have to take the wheel off

[samdust]

g force is wider than stock. its +2 and +4 so eather way ur gonna have to do that. make another gate or widen ur old one. it will be easier. i promise.

[91banshee]

i would extend the gate , so the quad could be rode threw it if possible , pain in the ass taking the wheel on and off

[Hilarious]

my problem is that i cant fit my shee threw my gate to my backyard with out taking the right wheel off, if i buy the g force axle can i adjust it so it fits threw my gate? and then when i get out of my gate extend it back out?

 

To my knowledge, the g force axle cannot be adjusted to be more narrow

than the stock axle.

Tilt that sumbitch on its side and push it through your gate.

[chevrolet banshee]

by the axle, put it on, bild a ramp, put it in front of your gate, jump the gate

thare you go

[91banshee]

by the axle, put it on, bild a ramp, put it in front of your gate, jump the gate

thare you go

[SoCalinIt]

I'm going with the jump the gate one... That one sounds fun!!!!

[yfzdunejumper]

A poor mans drag axle is to just put your rear hubs on backwards so your valve stems and lug nuts are on the inside. That will make your rear end narrow enough to fit in the gate....

[samc]

hahaha i was thinking about the jump but nahh.. umm i dont wanna shorten it anymore thoo