christ6 Posted April 13, 2007 Report Posted April 13, 2007 needed to adjust my clutch the other day and pulled the side cover off and noticed there was no nut and found a washer kinda ground up in the case, cleaned that up and found a nut that fit and loctighted it up and put it on, well today my clutch went limp i can only assume i lost the nut again, what the hell is going on here? any ideas? Quote
theshee Posted April 13, 2007 Report Posted April 13, 2007 There is a washer that locks the nut in place by bending down a tab. It most likely wasnt bent the first time, the nut came off, and now came off again since the washer was all ground up. Get a new nut, and new lock washer and put it back togehter, should work. :thumbsup: Quote
christ6 Posted April 13, 2007 Author Report Posted April 13, 2007 There is a washer that locks the nut in place by bending down a tab. It most likely wasnt bent the first time, the nut came off, and now came off again since the washer was all ground up. Get a new nut, and new lock washer and put it back togehter, should work. :thumbsup: 10-4 i didnt realise that washer had to be bent, i cant even remember if i put a washer in it the second time now that i think of it, thanks man Quote
theshee Posted April 13, 2007 Report Posted April 13, 2007 When you get a new washer, look and you will see where it can be bent down onto one flat side of the nut, that will prevent it from coming loose again... Hope that works for ya. :thumbsup: Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.