mikuni carb

[kawiking]

i have a set of 34mm mikuni round slide carbs and i need to get close on the jetting .dont know where to start. i need to get close,im going to put it on a dyno but i want to have close to the right jets to try.

 

 

drag port-cpi out of frame-shaved head(.30)-shaved reed cages-lightened flywheel-f.a.s.t clutch,reed spacers-bored .40 over -hot rod crank(stock).

 

i was running 310's in stock carbs without prting or pipes on a .30 over bore

[Banchetta]

i have a set of 34mm mikuni round slide carbs and i need to get close on the jetting .dont know where to start. i need to get close,im going to put it on a dyno but i want to have close to the right jets to try.

drag port-cpi out of frame-shaved head(.30)-shaved reed cages-lightened flywheel-f.a.s.t clutch,reed spacers-bored .40 over -hot rod crank(stock).

 

i was running 310's in stock carbs without prting or pipes on a .30 over bore

I'd start w/ 380's and work down from there..

[kawiking]

ive heard the jetting would be close to what i had in my stock 26's. ????????

 

if thats true 380 and work down sounds good!!