bansheecowboy Posted March 13, 2007 Report Posted March 13, 2007 i just rebuildt my shee i whent .030 over and added a avd. timeing plate. i was running 230 mains 25 poilt and needl at middle clip. after rebuild i have 320 mains 27.5 poilts and needle at 4th clip. it doesnt start5 right a way and to get it to idle i have to hold thotle about a 1/8 of the way open i dont have tors and i have air screw 2 truns out. any help would be great it was 80 today and i couldnt got riding because the shee isnt running right. elev. 3200 rest of mods below Quote
Banchetta Posted March 13, 2007 Report Posted March 13, 2007 Your way too rich. Try some 290 mains, 25 pilots, needle 4th clip...adjust the air screws to throttle response...Do you any air box mods? Filter? Quote
bansheecowboy Posted March 13, 2007 Author Report Posted March 13, 2007 (edited) i have twin air filter and stock box with the last 1.5 inch cut out. but right now i dont have anything on the carbs. i am trying to sinc them but need the shee to run by itself first, Edited March 13, 2007 by bansheecowboy Quote
Banchetta Posted March 13, 2007 Report Posted March 13, 2007 i have twin air filter and stock box with the last 1.5 inch cut out. but right now i dont have anything on the carbs. i am trying to sinc them but need the shee to run by itself first, Lower the pilots and adjust the air screws....Why do need it to run for syncing???? Take a flashlight. Look inside the intake and adjust the slides until they bottom out. Then raise the slide 1 full turn. Do this to both sides and you'll be all set... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.