Need some electrical help

[thedurf]

Ok here is the deal. I just got the shee back because i got it bored and they stripped out one of the holes for the connecting bolts(they had it for over a month just for that... :shoothead:) . But thats not the point. I got it all back together and tryed to start her up. Nothin happened, checked that the carbs were gettin fuel, they were, and checked for spark. There was nothin. I tested the actual rubber plugs for current, nothing. Unhooked the coil to check for power, nothin. Now i'm no expert, i know enough to get my own shit done, but i can't figure out why i'm not getting any power. I checked all the ignition wiring, everything is good and where it should be, no breaks nothin. Somebody please help me out, I'm dying to get this thing running. ::

[bertski077]

could the wires be burnt near the back right exhaust...? if you have an ohmeter and a manual check to see wat kinda current your suppose to get out of the stator...you can also check to see if your pickup coil is bad

[thedurf]

i'm not getting any current at all. thats the problem.

[Wallrat]

Use a multimeter to see if you've got juice prior to the harness. If you don't then its a stator issue.