bansheeryder21 Posted August 15, 2006 Report Posted August 15, 2006 (edited) Just got my bike ported by Kevin Herr (herrjugsracing.com) and now I need to dial in the jetting. I have the bike totally put together and it runs! It's a little suggish on the bottom and feels like is sputters a little! Does any body have 30mm CPW carbs with similiar mods to what I have??? Look at my sig. I want to know what you run and what you recomend for my bike! I'm new at jetting and really don't know how to get the right set up dialed in. If anyone can help me and tell me where to start that would help me out a ton! Thanks! :beer: ***I'm at sea level. Edited August 15, 2006 by bansheeryder21 Quote
wesw Posted August 15, 2006 Report Posted August 15, 2006 my brother in laws ran good with a 55 pilot, 5th clip with whatever needle it had and 150 mains. those needles are impossible to cross reference. dont knwo if they are rich or lean. at 1000ft. Quote
Shee-Male Posted August 15, 2006 Report Posted August 15, 2006 Just jetting mine yesterday, same sputter, it needed the 55 pilots (52's were in it) it's now breakin down at the top so gonna half to go larger on the mains 160's (155's are in it). adjust your pilot screw first and see where it works best. Quote
bansheeryder21 Posted August 15, 2006 Author Report Posted August 15, 2006 (edited) I adjusted my air screw to 1 turn out and it did a little better! I don't know what size jets are in there right now because they sent the carbs to me prejetted for my bike before I did the port! I am going to find out what's in there and let you know! I think my main is a 160 and my pilot is a 50. Don't know what needle clip it is on. Thanks for the help! Let me know what else you find out! Edited August 15, 2006 by bansheeryder21 Quote
bansheeryder21 Posted August 16, 2006 Author Report Posted August 16, 2006 found out my pilot-50 and main-162. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.