Bansh-eman Posted July 23, 2006 Report Posted July 23, 2006 im changing my impeller out but i didnt pay any attention befor i poped the bearing out of it.... the bearing seems to be sitting outside of the carrier just a little bit... is it posed to be flush or is this ok? Quote
Bansh-eman Posted July 23, 2006 Author Report Posted July 23, 2006 ok well i fixed this... i had to buy a new seal and pop to the old one out and use some assembly grease to get it all the way in... so it was keeping the bearing from seating all the way in.. Quote
steveodo Posted July 23, 2006 Report Posted July 23, 2006 yea new seals are good , did you get a pro design impeller? Quote
Bansh-eman Posted July 23, 2006 Author Report Posted July 23, 2006 it was a new seal in there already but it was bound up so of course it tore it when taking it out so i put a second new seal in there and used some assembly grease to make it slide in ezer, then used the old seal to tap it all the way in... i got a modquad impeller Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.