Shearer Pipe Hangers

[watkins]

Trying to mount up my shearers and my stock mounts aint getting it done. The Clutch side pipe actually fits fine and the stock hanger works for it... but the stator side.. the pipe hits the head and doesnt come in far enough.. so there is like almost a 1/2 gap in between the hanger and the pipe... any ideas?

 

Also.. where can I buy some bolts for the silencer mounts? Mine didnt come with any.. just need to know the size.

[Big Blue]

I had to use washers to space the bracket away front the head, leave everything loose until you get everything where you need it and then tighten everything down.

[watkins]

So I assume a longer bolt is in order. Do you know what size that bolt is?

[cdwood37]

it is either an 8mm or a 10mm i forget, get anoe about 40mm long and then a 1/2" spacer and all will be well i had the same problem but i spaced it and it was fine.

[watkins]

it is either an 8mm or a 10mm i forget, get anoe about 40mm long and then a 1/2" spacer and all will be well i had the same problem but i spaced it and it was fine.

 

Well.. i have some 8mm & 10mm bolts laying around and 8mm is just a hair too big, thats why i was figuring it was 7mm... can anybody chime in with an exact size.. i really want to get these pipes mounted up.... also.... is the silencer bolt the same size?

[KEVSWS6]

Well.. i have some 8mm & 10mm bolts laying around and 8mm is just a hair too big, thats why i was figuring it was 7mm... can anybody chime in with an exact size.. i really want to get these pipes mounted up.... also.... is the silencer bolt the same size?

 

I'm not sure on the size. Try pulling a bolt out of something else on the bike that looks like it will thread into the hole. Once you find the right thread pitch take note of the length. Then go to the local hardware store and pick it up. Even if you dont get the correct length you can cut it down with a hack saw. So error on the long side.

[greg_banshee]

8mm for exhaust hangers