00tbanshee Posted April 29, 2006 Report Posted April 29, 2006 If you want to make sure your pistons are not hitting your head do this. Revove your head,get a 1/4" piece of thin solder,run up piston to 1/2" from top of bore,then lay the solder on top of piston at outer edge of piston paralell to wrist pin. Bolt up head not using o rings,1 dome at a time. Slowly turn over piston till it goes over TDC. Then unbolt head & measure thinnest point of solder. This will be you squish. 509496[/snapback] what is the spec that it should measure Quote
fun_on_the_sand Posted April 29, 2006 Author Report Posted April 29, 2006 Hey guys, I just put the stock head back and the same sound. SO I think detonation is not the problem. I am not very familiar with the sounds when something is wrong, but this sounds like some plastic part is hitting somewhere. And listening closer is not from the water pump side, bur from the stator side, I already open the stator cover, but anything looks wrong... What do you think guys? Quote
duner Posted April 29, 2006 Report Posted April 29, 2006 what is the spec that it should measure 509567[/snapback] I would'nt go less than .025,with .030 to .035 clearance being what I prefer. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.