Jump to content

Recommended Posts

Posted

i was riding for about 3 hours yester and the bike ran flawless (other than the tranny not wanting to shift/shifting hard), but all the sudden I get on it today and after it warms up if i punch it from idle it will jsut die. Or if im rolling slow at a very low rpm and punch it it will bogg down and then go, almost like its flooding out? What would cause this all the sudden? Temps are the same.

Posted (edited)

It sounds to me like you need to change your spark plugs, and there also may be dirt in your carborator. You also might have a clog in your muffler. Your Air Filter also may be very dirty or have moisture in it. Oh ya, is your Banshee 100% stock?

Edited by brydon_hilder
Posted
moisture..... thats funny cuz i presurewashed it after I got done riding.....

 

Ill check the plugs too, thanks

465320[/snapback]

 

Ding! I bet that is your culprit. Mine acted very similar after I hid some big puddles at John's Peak with the Toomey 2:1 (no airbox). Depending on how much water you may have got in there it may clean out, or you may need to take the carbs off and clean them up. But my money is on the moisture.

Posted

I unplugged the TORS and it still did it, only thing differnt is it wouldnt idle with it removed.

Plugs look fine, air filter is clean......... it just bogs and will die if it is below maybe 3000rpm? But it will idle fine with the tors hooked up.

Posted
I unplugged the TORS and it still did it, only thing differnt is it wouldnt idle with it removed.

Plugs look fine, air filter is clean......... it just bogs and will die if it is below maybe 3000rpm? But it will idle fine with the tors hooked up.

465967[/snapback]

did you unplug just the tors, or did you also unplug the control box, under gas tank left side?

try spraying brake clean non chlorinated on the coil, this disperses the water. but make sure it's not the flamable type.

Posted

I wouldnt think it would be an ignition problem, Could be wrong though. It idles fine but has a hard time going from off idle to say 3000rpm, then after that it will fly. :bolt:

 

All I did was unhooked both the TORS, ill try unpluging the control box. Should this still cause it not to idle?

Posted
I wouldnt think it would be an ignition problem, Could be wrong though. It idles fine but has a hard time going from off idle to say 3000rpm, then after that it will fly. :bolt:

 

All I did was unhooked both the TORS, ill try unpluging the control box. Should this still cause it not to idle?

466240[/snapback]

Its your jetting, electrical would do it at high rpms as well...What are your mods, jetting??? Have you tried raising the needles? You have a lean condition. Where do your air screws like to be at? .5 turn out or 2.5 turns out?

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...