Cheetah Cub set-up

[courville69]

Hey guys what do you think of this for the price?

Would this be a good kit to buy?

My Webpage

Edited December 3, 2005 by courville69

[courville69]

Anybody have a opinion on this kit and the price or the seller for that matter.

[rocketboy]

link doesnt work for me

[courville69]

Might work now.

[Too Many Toys]

I checked around because I was going to go with this setup too. Thats actually a pretty good deal. It doesn't say if the cylinders have been nikasil plated or not though. From what I hear that runs another hundred to two hundred bucks. Looks like a decent deal though.

[courville69]

Now are these cylinders pre ported or do you have to do port work to them?With this setup what would a guess at hp be?

Edited December 3, 2005 by courville69

[BigRed350x]

Even if they aren't ported, the stock cub porting is supposed to be pretty damn good right off the shelf.

[bkabina]

Thats about the best deal you will find other than Passion.The cylinders you are asking about are plated and come with the stock cub port set-up.With good reeds,carbs,pipes,and head,You could see as much as 95hp from the stock port set-up.

[decon]

Now are these cylinders pre ported or do you have to do port work to them?With this setup what would a guess at hp be?

444409[/snapback]

 

here you go

 

http://www.bansheeracing.com/cubdynos.htm

[reded]

That is hella deal! Theres more to it than that though. You'll also need wrist pin bearings, gasket kit, stud extenders and water jacket plugs. It says that they are plated. They should make awesome power even with the stock porting.

 

Bit of advice as well, I waited 6 weeks getting my Shearers from those fuckheads at in2glamis. Never did receive a billet intake that I once won (via ebay) from them. Had to file complaint against them with Paypal and Ebay.

[rocketboy]

yeah in2glamis is kinda sketchy ,but there supposed to have remangaed their staf and improved customer service that kit is a smokin good deal IMO

[RNBRAD]

Customer service and a complimetary clean up port is worth something. I think the builders on this site could match that pretty close and get you the stuff you need. It sucks when you find out there's something you forgot when your in the middle of your build. That package is missing a lot of items to complete the project.

[FASTOYS]

Customer service and a complimetary clean up port is worth something. I think the builders on this site could match that pretty close and get you the stuff you need. It sucks when you find out there's something you forgot when your in the middle of your build. That package is missing a lot of items to complete the project.

444465[/snapback]

 

Word! That goes along ways! Kinda of nice to buy them from a engine builder that way they can walk you through the extras and tips on jetting , install, etc..

[23champ]

You will aso have to buy diff. domes. 68mm will require bigbore domes, and they will have to be custom cut for the proper squish angle.