outlawchico151 Posted November 22, 2005 Report Posted November 22, 2005 for some reason my banshee doesnt wanna fire....i had 2 cancel the key and i connected the red and black wires and it doesnt wanna fire it sounds lyk its STILL SWITCHED TO OFF...but both wires r connected Quote
2001Sheesmine Posted November 24, 2005 Report Posted November 24, 2005 Have you done anything with the carbs recently? I thought I had some kind of ignition problem after I cleaned my carbs but it ended up being that one of the slides in my carb was stuck wide open. Try rolling your bike down a hill and kicking it in gear. If it runs fine after you do that I dont think its the carbs. It will probably be somthing in your ignition or magneto. If its bogging out in higher rpm check your carbs. Quote
BansheeBoy17 Posted November 24, 2005 Report Posted November 24, 2005 Pull the plugs and do a spark test, if you see spark then you have spark... Kick it about 20 times, pull the plugs, if the plugs are wet then you are gettin fuel, but its not burning. Put you finger over the hole on the head while one spark plug is out, kick it over, if it blows your finger off then you have enough compression. thats basically all it takes to get an engine started - theres not really an resitrctions to air unless your filters are really dirty . Quote
FIRST BANSHEE Posted November 26, 2005 Report Posted November 26, 2005 to bypass your key switch all you have to do is unplug it, you do not need to connect any wires.try untwisting the wires and chrck for spark. good luck Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.