What pipe

[KJO89]

I wanted to know what is the best pipe for my type of riding. I do mostly hills, wide open riding and sometimes trails. I was lookin at shearer in fram pipes and dmc alien pipes. What do you think will be better thanks.

[Toomey Banshee]

mods?

[KJO89]

right now stock but this winter i plan on doing vforce reeds, and porting. Maybe more i dont know.

[wesw]

shearers are a mid to top pipe.

 

dmc are more of a low to mid pipe.

 

 

if your wanting balls out, wot power go with shearers.

 

if your more putting around, trails adn then some racing go with the dmc.

 

the dmc are good pipes. more all around pipe.

 

the shearers are probably the best drag pipe. it really depends on what exactly do riding wise.

 

if you have a clue on who is going to port it, youmight call them and talk porting and pipes so you can get your stuff lined out.

 

best of luck

[Hilarious]

Where did you get your shearers from, wesw?

 

Like your sig.

[KJO89]

ok thanks man! I think im gona order the shearers because i dont do that much trails only sometimes, and i love that top end power

[Toomey Banshee]

If you want top end the list should go something like this:

 

1. CPI

2. Shearer

3. T-5's

 

From what I have heard CPI has a bit more low end than Shearer. T-5's are a good pipe for stock motors and work well with porting. Shearer has more top end than the other 2. I have T-5's on 1 of my Shees and CPI's on another. I love both pipes, CPI's on a ported motor is the shit though.

[wesw]

passionre sells shearers for like 470 chromed. pretty good deal

 

pm him or call 918 232 3950

 

you will like them.

 

shearers usually out pull cpi on the top end

[KJO89]

with the shearer pipes will i lose or gain any low end power from stock? or stay about the same?

[wesw]

you might lose some i dont know never ran them on stock setup. but it will hit hard in the mid and top

most drag pipes you might lose some low end.

 

they like porting if you plan to do that in the future.

Edited November 20, 2005 by wesw

[locogato11283]

shearers are gonna kill ur bottom end. say bye bye. cpis will have more bottom end than shearer. personally id go with t5's..unless ur dragging all the time and wanna have all power on top end. if u want any bottom end at all stay awayfrom shearers.

[rocketboy]

Iknow when i switched from rockets to shearers i gained more bottom end -very top rpm shearers are just plain awesome pipes ,i wouldnt say bye bye to the bottom end... that depends alot on the port job and compression too IMHO

[PassionRE]

On stock porting, the Shearers will hamper bottom end over a CPI and other pipes as well.. But if ported with Shearers in mind, you can have just as much bottom end as CPI's and just kill the CPI's in the high R's and in peak HP numbers...Jim