onetwistedaccord Posted August 28, 2005 Report Posted August 28, 2005 ok i just bought my banshee. i dont know much about it. i know the motor just got bored.. new pistons and rings it has a boost bootle and k&n filter.. and pipes and all new seals. it has a twist throtle.. the needle is set on the highest setting all the way up. i dont know what jets are is there. i tried adjusting the idle screw doesnt help. it wont idle at all..and off the line the right side bank is not ignting lots off oil in the muffler but at 1/4 throttle and up it rips.. What should i do Quote
batoutofshell Posted August 28, 2005 Report Posted August 28, 2005 first you have to take the carbs off,needles back to third slot down and see what kind of jets you are running what kind of pipes do you have, how many slots are in your needles,there are alot of factors when jetting your bike for the first time after a rebuild. but those needles should not be that far up I will tell you that.Does it still have tors units or side idle screws? Quote
onetwistedaccord Posted August 29, 2005 Author Report Posted August 29, 2005 they have side idle screws and i belive there are five postions on the needle..there are also set screws on the top of the carbs? Quote
onetwistedaccord Posted August 29, 2005 Author Report Posted August 29, 2005 oh FMF gold series pipes Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.