sycoracer911 Posted July 28, 2005 Report Posted July 28, 2005 ok i recently pulled the banshee fully apart and apon doing so i have noticed that i can not find any light plugs well anyway does anyone know how i would wire light plugs into the wiring harness..... does anyone have a diagram of a wiring harness with each wire labled? please help me i neeeeed lights Quote
Cotton eyed Joe Posted July 29, 2005 Report Posted July 29, 2005 I don't have mine here, but you should get one QUICK. A Clymers Manual. Quote
it's stolen Posted July 29, 2005 Report Posted July 29, 2005 I think the low beam wire is green and the high beam wire is yellow. be careful because the power wire from the stator is also yellow Quote
sycoracer911 Posted July 29, 2005 Author Report Posted July 29, 2005 ok i see a green one that was cut and tapped off.... if i get a light from wally worl and hook the poitive up to the green and then ground the black wire..... will that work if i put it on low beam Quote
Shee-Male Posted July 30, 2005 Report Posted July 30, 2005 You should ask BenBB or check out his wiring FAQ it has a diagram, and wire it up to high beam, I belive the wire from the voltage regulator runs all the lights so you might be able to run right off of that with a switch. Quote
it's stolen Posted July 30, 2005 Report Posted July 30, 2005 ok i see a green one that was cut and tapped off.... if i get a light from wally worl and hook the poitive up to the green and then ground the black wire..... will that work if i put it on low beam 398592[/snapback] should work ok but the stock stator will have a hard time lighting 2 55 watt bulbs. mine is dim at idle Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.