jaysea1 Posted February 6, 2005 Report Posted February 6, 2005 Fellow HQ'ers...just installed +4 swingarm, new 13 tooth sprocket/41 in rear, and new DID chain in rear. Installation went very well. I think I may have cut chain a link too short though. I have about 3/4 inch of play with no weight on bike...about 1/4(maybe) with weight on bike. Any how, runs fine until I try to gas her up a little. It almost feels like the engine does not want to go any faster. Nothing is binding...axle/carrier/wheels,sprockets,chain all turn freely. I did remove parking brake and still have the TORS on, any ideas? Quote
EastCoast Banshee Posted February 7, 2005 Report Posted February 7, 2005 I had the same problem the other day. Make sure you cut the switch off or find some way to hold it in. Quote
mat Posted February 7, 2005 Report Posted February 7, 2005 How did you remove the parking brake? If you just unplugged the wires from the clutch perch, then that is your problem. You need to follow the wires back to near the steering stem and disconnect them there. Quote
jaysea1 Posted February 7, 2005 Author Report Posted February 7, 2005 Thanks Mat, I'll do that, I figured it might be a TORS issue, just ordered new thumb throttle kit to illiminate TORS Quote
jaysea1 Posted February 7, 2005 Author Report Posted February 7, 2005 Thanks again guys, I unplugged the connector @ steering stem area from the clutch perch as suggested, and that did the trick. Quote
mat Posted February 8, 2005 Report Posted February 8, 2005 Glad to hear that it is fixed. You obviously aren't the first one to do this. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.