01bansheeke Posted October 15, 2004 Report Posted October 15, 2004 Need to figure this out. I moved the needle down to lean it out in the middle. All of the sudden it idles high(er than normal)..ok no huge deal. Than earlier, i took the mains out to install bigger mains. I get it all done and fire it up...and it revs to the friggen moon. I looked at the slide and the left side(shift side) is slightly higher than the other..could this be it? Is it possilbe the something is in the slide keeping it from going all of the way down or what? THis is drivin me nuts and the bhq little sahara trip is only a week away. Gotta get this done. thanks in advance for the help. Quote
racer Posted October 15, 2004 Report Posted October 15, 2004 make sure your slides are in correctly, cutouts towards the rear axle. Quote
Toomey Banshee Posted October 15, 2004 Report Posted October 15, 2004 check for an air leak somewhere as well. Quote
bigboybanshee Posted October 15, 2004 Report Posted October 15, 2004 I had the same problem and I had forgot to put the choke tube back in between the carbs... Quote
rasta Posted October 15, 2004 Report Posted October 15, 2004 or the cable could be hung up somewhere. if the left carb slide is higher than the left than that will cause it to idle fast though, so adjust that cable so the slide bottoms out Quote
01bansheeke Posted October 16, 2004 Author Report Posted October 16, 2004 how do you adjust the cable>? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.