Bongshee Posted September 28, 2004 Report Posted September 28, 2004 Im looking to clean my bike up a bit so i can powdercoat my frame. What is involved in cleaning up my wiring hareness a bit and eliminating the wires that provide power to Brake lights, ignition etc. Will it affect anything and is there a a safe place to start at? I no longer have any use for half the electrical....just looking to clean up its appearance. Quote
rebelbanshee2 Posted September 28, 2004 Report Posted September 28, 2004 all you NEED in the main harness to make it run is the orange coil wire, the red/black wire. to be spliced spliced into ground, a ground (black) coming off the coil and the black/white wire going into a kill switchalong with a ground (black) For lights the yellow and black wires from the stator the blue voltage reg wire splied into the yellow wire. A gound coming off the housing of the volt reg. the yellow tied into a switch and then into the lights, with the black light wires being grounded. this is for headlights only..no tail light or low beam Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.