chase73 Posted March 3, 2004 Report Posted March 3, 2004 hey all I have to remove the sterring post bearing and there is a nut on the top has anyone ever made a tool to remove this and what size nut did you use ???? i figured I could just weld a couple together to remove it Quote
Cotton eyed Joe Posted March 4, 2004 Report Posted March 4, 2004 I sell a wrench. $12.00 - 10% = $10.80 plus free shipping. It will fit on the end of a 3/8 drive. Quote
chase73 Posted March 4, 2004 Author Report Posted March 4, 2004 no thanks it will only cost me 50 cents to make one I just needed the size nut to weld . but , thanks for the offer It is only a one time use tool so why bother buying it right Quote
DIRTBIKEZ Posted March 4, 2004 Report Posted March 4, 2004 Measure the retainer and you'll get your nut size . Quote
Aussie Quad Racer Posted March 4, 2004 Report Posted March 4, 2004 30mm from memory. I made one too by welding a bolt and nut up Quote
boonman Posted March 4, 2004 Report Posted March 4, 2004 30mm is the wrench size. It is the measurement from flat to flat. I don't know what size bolt it is though. But, i do know that a 3/4" bolt is very close. Get ya a bolt, and a nut, weld them together, and presto.... Quote
chase73 Posted March 4, 2004 Author Report Posted March 4, 2004 thanks i will make one up tonite Quote
chase73 Posted March 10, 2004 Author Report Posted March 10, 2004 worked like a charm just welded the bolt to the not and it came off 35 well spent cents Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.