36mm kehin jetting help

[jason.perez]

I’m building a new motor: 

t5’s 

4mm long rod crank 

68mm bore 

hjr mx hardcore port w/ case match

vforce 4 reeds 

cool head 24cc milled domes   Since I’m trying to run pump gas 

and 36mm pwk air strikers 

3000ft

was wondering what Jets I need to run just to be in the ball park  Im used to the mikuni jet sizes   The only needles I have  are what is stock in the carbs and also what bp racing supplied me with  Im sure those needles are fine  all the gave me was two differnt main Jets and no pilots (and they call that a jet kit) what Jets should I order  thanks in advance 

also, if I Plan to swap out the domes and run race gas would that change my jetting ? 

 

[jason.perez]

Also forgot to ask what float height to run them at?

[locogato11283]

The PWK will come with their own needle. Most PWK take 45-50 pilot and 155-165 main, depending on temp and elevation.

[jason.perez]

They gave me CEL needles I think I’ll just run then middle clip for now. I put 45 pilots and 165 mains in sure there gonna be to Rich since when I jet it it’s going to be 3000 feet I stead of where I’m located at 300 ft

[locogato11283]

Yea, Likely have to drop to a 155-150 main for that elevation. The pilot will probably be fine.