Jump to content

Recommended Posts

Posted

I recently took my banshee apart and cleaned everything then put it back together. Once I start it it sounds like it's about to blow up, I tried messing with the carbs syncing still loud. Then I made sure I synced them correctly and it still sounds like it's about to explode when I start it. I don't want to take it to a shop cause I worked on everything and I don't want someone else to tighten some screws after I did all the work on it. 

Help please!

Posted

Haha my bad

I didn't take the whole thing apart and reassemble it. I deep cleaned the radiator, both of the carbs and the filter. I didn't mess with the pistons or the gear shift.

I should note that it gets super loud on idle but I can't just start it and immediately drive it.

it gets loud when it's idle and when I pull the clutch when driving it.

Posted

It rev's high on its own like I'm pushing the gas all the way (while its on idle). It didn't do it before i didn't change anything with the muffler. I pulled it apart because there was too much dirt inside and it wouldn't start.

There's no knocking or grinding

Posted

See if one of your slides are stuck up & sync them, if you didn't do 1 carb at a time~ make sure you put correct   bowl on correct carb, correct slides in correct carb ( facing correct way), crossover choke tube back on  , and do a leak down test

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...