r_gillies Posted April 25, 2016 Report Posted April 25, 2016 Owned quad for about ten years now and it had a very hard life before me. Last fall went through crank and bored out cylinders to run 66mm wossner Pistons. Used proper engine gaskets for large bore. Stock timing, head, carbs. Pc pipes and midrange porting. Rode about 6 tanks and seized mag side crank bearing. Bearing piled up so hard it pushed crank apart. Upon closer look my Pistons are hitting stock factory head right at edge of squish band. I'd like any suggestions on how to properly modify a replacement head and approximately what it would cost. Thanks. Sent from my iPhone using Tapatalk Quote
Larry's Shee Posted April 25, 2016 Report Posted April 25, 2016 Site sponsor Mull Engineering ,about $90 Something is fucky. 1 Quote
r_gillies Posted April 25, 2016 Author Report Posted April 25, 2016 My machinist said Pistons were tapered down at squish band no head mod needed. is it possible that using the thin cometic base gaskets caused this as oem are quite thick. Sent from my iPhone using Tapatalk Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.