bansheeboie Posted September 10, 2015 Report Posted September 10, 2015 Like title says hot rods 4mil long rod crank, trued/welded with max load & TZ bearings. 0 hours on it since rebuilt. Have the paperwork as well from Brandon to show proof of rebuild. Will get pics up in the am. $480 shipped. Quote
Strm Trpr Posted September 10, 2015 Report Posted September 10, 2015 I tried sending you a PM. I've read about TZ bearing failures when the PTO side had stock beveled gears? I'd imagine it was because of something else though. Thoughts? Quote
bansheeboie Posted September 10, 2015 Author Report Posted September 10, 2015 My inbox is empty, should be good to send pm. And as far as the failure on the bearings with stock gears, I'm not too sure about. Failure Could have been due to something else. Would have to ask a builder. I just asked Brandon to rebuild me a crank that was reliable with these bearings. Quote
Deadbeat Posted September 11, 2015 Report Posted September 11, 2015 I tried sending you a PM. I've read about TZ bearing failures when the PTO side had stock beveled gears? I'd imagine it was because of something else though. Thoughts? too much HP on stock bevelled gears is why that TZ failed, if you cheap out on straight cuts on a high HP build the sideloading is too much for TZ`s, Max Loads or whatever you decide to run 2 Quote
Strm Trpr Posted September 11, 2015 Report Posted September 11, 2015 too much HP on stock bevelled gears is why that TZ failed, if you cheap out on straight cuts on a high HP build the sideloading is too much for TZ`s, Max Loads or whatever you decide to run Ahh yes, that's what I thought. Thanks for clearing that up Deadbeat!! Quote
possum Posted September 11, 2015 Report Posted September 11, 2015 Some builders dont even understand how a tz dont make any sense without straight cuts. Sure you can do it, but is it right. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.