Hey guys need help with my banshee

[ray408]

Recently changed clutch. When I removed the clutch cover i found a tiny ball bearing in oil any ideas thanks

[ray408]

No smaller than a bb

[bigweav81]

Hmmmm

 

Sent from your mammy house

[ray408]

[ray408]

I just had motor build by a sight sponsor and after first ride the idler gear came off, clutch slipped at 1/2 throttle and needle came off in carb just trying to find out if i should continue to put it back together or what could have happened

[ray408]

Or of course put it back together and ride it until it dies lol

[ray408]

I did with little to no help then I had redline help me figure out with my clutch problem but there not open today

[bigweav81]

Who was the site sponsor?

 

Sent from your mammy house

[ray408]

East coast atv

[Larry's Shee]

rut roh

[ray408]

Now just put it back together and won't move in gear did i adjust clutch wrong? Wtf

[bigweav81]

They say good work isn't cheap, and cheap work isn't good. What made you decide to go with. East coast atv?

 

Sent from your mammy house

[ray408]

That's a good question lol i guess life lessons are not cheap what builder would you recommend

[bigweav81]

Haven't used any yet. Redline, or fast. Hundreds of ppl can't be wrong. Always search, before you buy. These guys have been using, and testing shit for years on here, dickheads or not their opinions are valuable.

 

Sent from your mammy house

[ray408]

I've talked to redline and ordered parts from them very nice to talk to and very fast on the parts