mvvette97 Posted November 12, 2014 Author Report Posted November 12, 2014 Then there is no need for a spacer plate. That's what I was wondering. I ordered a .020, .030 and a .040 base gaskets but not sure what one to use. I tried to mease the old one and it looks like it was about a .035 thick on the outside edge but where is had been compressed was about .025 or a bit less Quote
mvvette97 Posted November 12, 2014 Author Report Posted November 12, 2014 By the way what size is my engine? .040 over bore with the 4mil stroker Quote
Bennett131 Posted November 12, 2014 Report Posted November 12, 2014 I can't tell you what base gasket to run, you will have to check your squish and move forward from there. Quote
Bennett131 Posted November 12, 2014 Report Posted November 12, 2014 Pic looks kinda small to me...if you can't see it, it's 385cc. Quote
mvvette97 Posted November 13, 2014 Author Report Posted November 13, 2014 Pic looks kinda small to me...if you can't see it, it's 385cc. Thanks man, that's a good chart. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.