Driveline Performance Lock-Up

[jriffe23]

Just wonder what kind of outer case modification is needed to use a driveline performance lockup.  Their website says "with minimal modification to the case", so my question is what is "minimal modification"?

 

[trickedcarbine]

Three tits inside from the three screws that hold the little plastic cover. Make them flat with the rest of the webbing. Done. Use thread locker to keep the insert screws from leaking.

[jriffe23]

Three tits inside from the three screws that hold the little plastic cover. Make them flat with the rest of the webbing. Done. Use thread locker to keep the insert screws from leaking.

 

Thanks! Drimel im guessing?

[trickedcarbine]

Dremel will probably work. It'll suck, but might work.

[jriffe23]

What do you think will be the easiest option. I picked one up for $150 still in the plastic.

[WINDYCITYJOHN400]

Any grinder will work. Just grind till you see the screws.

[apeik]

orbital palm sander with 60-80 grit discs...works amazing and takes down the waffle and everything if you have one.

[jriffe23]

orbital palm sander with 60-80 grit discs...works amazing and takes down the waffle and everything if you have one.

 

sounds like its going to be easy with this method. Thanks a lot!

[trickedcarbine]

Easy, maybe. Not fast though. Bet it'll look good though

[camatv]

right angle die grinder with sanding disc

[apeik]

both work fine, but it actually only took maybe 10-12 minutes with a low grit disc, and there's quite a bit less mess.