Pushrod Needle Bearing Kit

[mcaf29]

Where can I get the pushrod needle bearing kit like the one sold by GRR. I've looked on ebay for the past week with no luck. GRR's phone line is always busy and when I got through and left a message I haven't gotten a call back. They really should have online ordering if they are that busy. So does anyone know any other shop that sells them.

[NYUK]

SEND AN EMAIL TO ANDY,HE WILL GET BACK TO YOU.HE IS MAD BUSY AND HE S A ONE MAN SHOW.

[Badbanshee_boy]

dynoedge sells them.

[mcaf29]

Nyuk, Thanks didn't realize that he was the only one running the place. I sent him an e-mail.

[mcaf29]

I'm so aggrivated that these are the only two shops in the country that sell the kit. Neither shop has gotten back to me either. I wanted to order this kit last week so I could get it in time to put it together this saturday. I have eveything showing up tomorrow. I guess I'll just have to go without it. Unless someone knows of place that I can order it from ASAP.

[mcaf29]

O.K. got ahold of Dynoedge. After all that you needle to machine the lifter to use this mod. I'll have to see how much that'll cost before I try this mod and if I can get it done soon.

[Badbanshee_boy]

my dad had it done at dynoedge and it was like 60 installed. but the only reason he had then install it is becase they had his engine so it might be cheaper

[mcaf29]

Yeah, the guy at Dynoedge was really cool. He helped me out alot. I just ordered the bearing and dropped the lifter off at my machinist. It sounds easy enough, I'll find out soon enough.

[Badbanshee_boy]

if you have had your clutch out before its easy all u do is put it between the lifter and the bashet. i think. but with my dads they didnt machine the hole big enough and the clutch kept sliping until we re-drilled it. and the guys at dyno edge are usualy real nice guy's. i like doin buisness with them.